How To Hang Your Ceiling Fan - Emerson CARRERA GRANDE ECO CF788CK00 Owner's Manual

How to Hang Your Ceiling Fan

WARNING
!
The fan must be hung with at least 7' of clearance
from floor to blades (Figure 10).
WARNING
!
The outlet box and joist must be securely mounted and
capable of supporting at least 50 lbs. Use only a U.L.
outlet box listed as "Acceptable for Fan Support of 22.7
kg. (50 lbs.) or less".
WARNING
!
To reduce the risk of fire, electric shock, or
personal injury, mount fan to outlet box marked
"Acceptable for Fan Support of 22.7 kg. (50 lbs.)
or less", and use screws supplied with outlet box.
Most outlet boxes commonly used for support of
light fixtures are not acceptable for fan support
and may need to be replaced. Consult a qualified
electrician if in doubt.
1.Securely attach the hanger bracket to the outlet box
using the two screws supplied with the outlet box.
(Figure 11.)
2. Carefully lift the fan and seat the hanger
ball/downrod assembly on the hanger bracket that
was just attached to the outlet box (Figure 12). Be
sure the groove in the ball is lined up with tab on
the hanger bracket (Figure 11).
WARNING
!
Hanger bracket must seat firmly against outlet box. If
the outlet box is recessed, remove wall board until
bracket contacts box. If bracket and/or outlet box are
not securely attached, the fan could wobble or fall.
WARNING
!
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
WARNING
!
To avoid possible fire or shock, do not pinch wires
between the hanger ball/downrod assembly and
hanger bracket.
AT LEAST
7'
Figure 10
NOTE: CEILING COVER
OMITTED FOR CLARITY.
TWO SCREWS
SUPPLIED WITH
OUTLET BOX
Figure 11
Figure 2
NOTE: CEILING COVER,
SUPPLY WIRES AND
FAN WIRES OMITTED
FOR CLARITY.
Figure 12
10
CEILING
FLOOR
OUTLET
BOX
HANGER
BRACKET
TAB
OUTLET
BOX
HANGER
BRACKET
HANGER BALL/
DOWNROD ASSEMBLY
ETL Model No.: CF788