Maintenance Instructions; Centering The Running Belt - Sunny Health & Fitness SF-T1414 User Manual

MAINTENANCE INSTRUCTIONS:

General cleaning will help to prolong the life of the treadmill and improve performance.
Keep the unit clean and maintained by dusting the components on a regular basis,
cleaning the two exposed sides of the running belt to prevent dust from accumulating
underneath the belt. Keep your running shoes clean so that dirt from the shoes doesn't
wear the running board and belts out. Clean the surface of the running belt using a
clean damp cloth. Be careful to keep liquid away from electrical parts and running belts.

CENTERING THE RUNNING BELT:

Place the treadmill on level ground and set it to run at 3.73-5mph to check if the
Running Belt (No. 20) drifts.
1. If the Running Belt (No. 25) moves
to the right, turn the adjusting bolt on
the right side ¼ turn clockwise, then
turn the left adjustment bolt ¼ turn
counter-clockwise. If the belt does
not move, repeat this step until it
centers, refer to diagram "A".
2. If the Running Belt (No. 25) moves
to the left turn the adjusting bolts on
the left side ¼ of a circle clockwise,
then turn the right adjustment bolt ¼
turn counter-clockwise. If the belt
does not move, repeat this step until it
centers, refer to diagram "B".
3. Over time the Running Belt (No.
25) will loosen. To tighten the belt turn
the Left & Right side adjustment bolts
one full turn clockwise, check the
tension of the belt. Continue this
process until belt is at the correct
tension. Make sure to adjust both
sides equally to ensure correct belt
alignment. Refer to diagram "C"
22
C