4. Place the new activated charcoal filters
on the left and right side of the motor: Put
the holding lug into the rectangular open-
ing, place the filter onto the motor, and let
the locks click into place.
5. Place the grease filter (17) with the pins
into the openings.
6. Slide the lock (16) to the left; snap the
grease filter (17) in and release the lock.
7. Close the cover (15) again and allow it to
click into place.
8. Switch the power back on.
9. Dispose of the used charcoal filter with
household waste.
Replacing the LED light
WARNING
Risk of injury!
Should one of the LEDs stop working,
■
(15)
it must be changed by an authorised
service technician.
Note for the service technician:
(16)
This exhaust hood requires LEDs with
the ILCOS D code
(17)
DBS-2/65-H-120/33, AC 110-240V, max. 2W.
Page EN-11
Operation