Before Getting Started; Place The Drill Holes; Attaching The Exhaust Hood - privileg SY-103E9A-P1-C84-L121-600 User Manual

Page EN-16 Assembly

Before getting started

• Read chapter „For your safety" on page
EN-4 and all the safety notices.

Place the drill holes

WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
Before drilling the holes, ensure that
■
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
The distance between the cooking
■
surfaces and the lower edge of the
Exhaust hood must be at least 65 cm
for gas cookers.
For gas stovetops, you must read the
■
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the cooker, first use a
pencil to draw a vertical guiding line on
the wall.
Ideally, use a level or a plumb bob from
the ceiling of the room to the middle of the
cooker.
2. Draw the six drill holes on the wall accord-
ing to the diagram on page EN-15. Make
sure the distances between the holes are
correct.
3. Drill holes at the marked points, using a
diameter that can accommodate the dow-
els.
4. Place the dowels into the holes.

Attaching the Exhaust hood

(5)
5. Place the check valve (5) into the opening
on the top of the Exhaust hood (1).
Make sure that the pins on the valve are
facing outwards.
6. Screw the two round-head screws (11) for
mount the Exhaust hood into the dowels.
There must be enough space between
the wall and the heads of the screws so
that the Exhaust hood exhaust hood can
be hung by the keyhole openings.
7. Flip the cover (15) up.
8. Open the locks (16) on the grease filter
(17) and carefully remove the grease filter
(17).
(15)
(16)
(17)