Kärcher T-Racer Manual page 7

Cleaning wall surfaces
Fasten the T-Racer directly to the high-
pressure gun.
Press the bayonet connection of the T-
Racer into the connection of the high-
pressure gun, then turn by 90° until it
locks into place.
Tighten the safety cover.
Caution
Illustration
Always hold the T-Racer at the handle
while cleaning the walls.
Adjust the turning handle "power" as
per the surface to be cleaned
Control elements
"Power" turning handle
The turning handle "power" is used to
change the distance of the high-pressure
nozzles to the surface to be cleaned.
Robust surfaces (for e.g. tiles, concrete,
stone)
Illustration
Set turning handle "power" to "MAX".
For the effective cleaning of hard-to-re-
move contamination.
Sensitive surfaces (for e.g. wood)
Illustration
Set turning handle "power" to "MIN".
For the gentle cleaning of sensitive sur-
faces.
Foot pedal for surface cleaning
Illustration
For normal surface cleaning, press the
foot pedal for surface cleaning.
A water stream will be emitted from the
two high-pressure nozzles in the rotor
arm.
Foot pedal for edge cleaning
Illustration
For edge and corner cleaning, press the
foot pedal for edge cleaning.
A water stream will be emitted from
green high-pressure nozzle.
Troubleshooting
High-pressure cleaner does not build up
the pressure or is vibrating.
Dismantle the high-pressure nozzles,
check the high-pressure nozzles for
damage, rinse the T-Racer with clean
water then reinstall the high-pressure
nozzles.
Cleaning the high-pressure nozzle
Illustration
1 Remove the clip.
2 Pull out the high-pressure nozzle.
Rinse the high-pressure nozzle with
clean water, replace if necessary.
3 Insert the nozzle.
4 Re-insert the clip.
General information
Environmental protection
The packaging material can be recy-
cled. Please do not place the packag-
ing into the ordinary refuse for disposal, but
arrange for the proper recycling.
Old appliances contain valuable ma-
terials that can be recycled. Please
arrange for the proper recycling of old
appliances. Please dispose your old appli-
ances using appropriate collection sys-
tems.
Notes about the ingredients (REACH)
You will find current information about the
ingredients at:
http://www.karcher.de/de/unternehmen/
umweltschutz/REACH.htm
Spare parts
Use only original KÄRCHER spare parts.
You will find a list of spare parts at the end
of these operating instructions.
You can use the extension pipes with any
other Kärcher accessory.
Tip
English 7