Using The Breast Pump - Philips AVENT SCF396/11 Manual

English
12
Caution: During disinfection with boiling water, prevent the bottle or other parts from
touching the side of the pot. This can cause irreversible product deformation or damage
that Philips cannot be held liable for.
5 min.
1. Fill a household pot
with enough water to
cover all parts and place
all parts in the pot. Let
the water boil for
5 minutes. Make sure the
parts do not touch the
side of the pot.

Using the breast pump

Cushion size
The Philips Avent single/double electric breast pump has a soft, active cushion. It gently stimulates your
nipple to trigger milk flow. The cushion is made of flexible silicone, that adapts to up to 99.98 % of women,
fitting nipple sizes up to 30 mm.
Charging the breast pump
Fully charge the battery before you use the breast pump for the first time and when the battery is low. Fully
charging the battery takes up to 4 hours.
3 sec.
1. Switch off the device.
2. Allow the water to
cool down.
2. Insert the adapter into
the wall socket and
insert the small plug at
the other end into the
motor unit.
3. Gently remove the
parts from the water.
Place the parts on a clean
surface/tea towel or
drying rack to air-dry.
3. The battery is
charging.
4. Store the dry items
safely in a clean,
protected area until
needed. Ensure that the
clean parts have air-dried
completely before
storing them to help
prevent germs and mold
from growing.
4. When the battery is
fully charged, remove
the adapter from the
wall socket and pull the
small plug out of the
motor unit.