Table Support - Woodstock H0626 Instruction Manual

Table Support

1. Thread the 12mm table lock handle 3 turns
into the table support bracket.
2. Insert the pinion into the hole on the side of
the table support bracket from the inside,
starting with the pinion shaft. Figure 9.
Align setscrew in crank handle with flat,
Figure 10, on pinion shaft and secure using
®
the 3mm Allen wrench provided.
3. Insert the lock shoe into the table support
bracket and secure with setscrews on either
side. Figure 11.
Figure 9. Insert the pinion gear from the inside.
Figure 10. Align setscrew with flat on pinion.
Lock shoe
Figure 11. Lock shoe Inserted into table bracket.
- -
10