Operating Instructions; Using Osd Controller; Description Of The Joystick Operation; Description Of The Motorized Zoom&Focus Adjustment - Eneo MPB-72M2812M0A Quick Installation Manual

Operating instructions

Using OSD controller

Setup menu can be accessed and controlled by OSD control joy stick on the side of cam-
era unit. Five commands are available with the joy stick.
SUB-OUT
Video Sub-out Connector
ZOOM

Description of the joystick operation

1. SET Key (●) : Access to the menu or enter the setting. To enter the main menu,
press the Set Key down for about 1.5sec
2. UP/DOWN Key (▲/▼) : Choose the desired sub-menu and to move the cursor up or
down.
3. LEFT/RIGHT Key (◄/►) : Set up the value of the selected menu. Used to adjust the
desired menu selection and to move the cursor left or right.
4. '☟' denotes the long press down straightly for about 2 seconds
Description of the Motorized ZOOM&Focus adjustment
Works only when OSD Menu is inactive.
i
1. ▲ : Zoom In
10
Cover Open
OSD Control Joy Stick
2. ▼ : Zoom Out
3. ◄ : Focus Near
4. ► : Focus Far
ANALOG OUT0 should be set to TVI MODE, AHD MODE or CVI MODE to get CVBS
i
video in sub-out. If it is set to CVBS, there is no CVBS video in sub-out port. (SYSTEM>
OUTPUT> ANALOG OUTPUT0)
i If CVBS video is enabled through ANALOG OUT0 or Sub-out port, WDR and 3D-NR
functions are disabled in all video outputs. It should be considered when installer adjusts
the video with installation monitor via CVBS video signal.

OSD menu startup

Press the 'OSD menu SET key' down to access the setup menu mode.
• EXIT : Enters 'EXIT' menu with save current setting or without save.
• RETURN : Returns to the previous menu.

OSD menu table

MENU SUB MENU CONFIGURATION
DC MODE (INDOOOR, OUTDOOR, DEBLUR)
LENS
MANUAL
AF MODE ZOOMPUSH, MANUAL
MODE CHANGE ENABLED, DISABLED
SCANNING HALF, FULL
ZOOM / FOCUS
ONEPUSHAF ON
SYNC TDN ON, OFF
INITIAL ON
EN
11