Lubrication; V-Belt; Schedule - Grizzly G9933 Instruction Manual

Lubrication

The only parts on this machine that require peri-
odic lubrication are the ways where the cartridge
slide rides on the elevation housing and where
the worm gears and bushings are located. Use a
light grease or anti-seizing compound on the
ways and worm gear, and give the shaft mount a
shot of light oil.

V-Belt

Avoid getting grease or oil on the V-belts or pul-
leys. Check the V-belts, as part of a monthly
inspection for proper tension and belt condition.
Cracking and glazing could result in belt failure.
Replace the belt if such conditions appear.
G9933 Three Spindle Shaper

Schedule

Regularly blow out air vents with compressed air
and keep exhaust port clear.
For every 1 hour of use, clean and spray an
application of Boeshield
• Table
• Fence faces
• Miter slot
For every 5 hours of use, clean and oil:
• Spindle columns and cartridges
• Offset adjustment mechanisms on fence
• All worm drive and other gears
Once a year, replace the V-belt.
®
T-9:
-25-