Operations; Rotation - Grizzly G9933 Instruction Manual

SECTION 6: OPERATIONS
Disconnect power to the
machine when perform-
ing any adjustments or
maintenance. Failure to
do this may result in seri-
ous personal injury.
Always
mask when operating
the shaper. Using this
machine produces saw-
dust which may cause
allergic reactions or res-
piratory problems.
NOTICE
The following section was designed to give
instructions on the basic operations of this
shaper. However, it is in no way compre-
hensive of every shaper application. There
are many different jigs that can be built to
increase safety, accuracy, and types of
cuts. WE STRONGLY RECOMMEND that
you read books, trade magazines, or get for-
mal training to maximize the potential of
your shaper.
G9933 Three Spindle Shaper
Keep clothing rolled up
and out of the way of
machinery and keep
hair pulled back.
Wear safety glasses dur-
ing all operations on the
shaper. Failure to com-
ply may result in serious
personal injury.
wear a
Your
FORWARD/REVERSE switch as shown in
Figure 18. In many instances, it will be necessary
to flip the cutter over and reverse cutter rotation.
Whenever possible, mount the cutter so the
board is milled on the bottom side. This does a
better job, and it is safer for the operator.
Always check the direction of cutter rota-
tion before beginning any shaping opera-
tion.
dust
Figure 18. Forward/reverse switch.
This machine was designed to be started
and stopped with the START/STOP but-
tons—not the reversing switch.

Rotation

shaper is equipped
NOTICE
with a
-19-