Table of Contents
Advertisement
Fence Adjustment
The fence is a two-piece adjusting system. Each
fence is independently adjustable to compensate
for different cutting thicknesses and special shap-
ing applications. To adjust the fence see Figure
10 and follow the instructions below:
1.
Loosen the fence lock handle.
2.
Turn the fence adjustment knob until the
fence is set to the desired position.
3.
Tighten the fence lock handle.
More detailed information concerning fence
adjustments is covered in the "Straight Shaping"
instructions.
Lock Handle
Figure 10. Fence controls.
-14-
Adjustment Knob
Aligning The Fence
The following procedure ensures that the fence is
parallel with itself and square with the table.
1.
Check that the bolts through the wood facing
are tight on each side and adequately coun-
tersunk.
2.
To align the wood facing, adjust one or both
fence halves so they are in close alignment.
Micro-adjust and check the alignment with a
straightedge as shown in Figure 11.
3.
If the wood fences are not coplanar with
each other, shim the fence where it attaches
to the fence bracket until both fences are
coplanar.
Figure 11. Aligning fences with straightedge.
G9933 Three Spindle Shaper
Advertisement
Table of Contents
