Installing The Burner Components; Verifying Proper Operation - Dacor Preference SGM466B Installation Instructions Manual

Installing the Burner Components

WARNING
• Never attempt to operate the cooktop with any of the
burner parts removed.
• Do not attempt to adjust the burner air mixture set-
tings. All adjustments are preset at the factory.
1. Remove the burner heads, burner rings, burner caps
and grates from their shipping packages.
2. Install the burners as shown. When installing the burn-
er components, twist each piece back and forth slightly
until it drops completely into place. The burners will
not operate properly unless all of the burner pieces are
properly seated.
3. Gently set the grates on top of the spill tray. Make sure
that the rubber feet are positioned in the dimples.
Cooktop Burner Components
5 places
Burner Ring Installation Detail
Installation Instructions
Grate
Burner cap
Burner ring
Top frame
Burner head
(fixed)
Tabs
Notches
5 places

Verifying Proper Operation

WARNING
• Make sure that power to the electrical outlet is turned
off at the circuit breaker panel or fuse box and that
the gas is turned off at the gas supply valve before
proceeding.
• The cooktop must be properly grounded at all times
when electrical power is applied.
Prior to operating the cooktop, read the accompanying use
and care manual carefully.
1. Make sure all the cooktop burner controls are in the
OFF position.
2. Connect the power cord to the electrical outlet.
3. Turn on power to the electrical outlet at the circuit
breaker or fuse box.
4. Depress and turn one burner control knob at a time
slowly counterclockwise to the HIGH position. Verify
that the associated burner igniter sparks, then return
the knob to the OFF position. Repeat for all of the
remaining control knobs.
5. Turn on the gas supply valve.
6. Perform the following ignition test for all of the burners:
• Press and turn the control knob slowly counter-
clockwise to the HIGH position. Only the selected
burner will spark. It may take up to four seconds
for the burner to ignite, at which time the igniter
will stop sparking. If ignition does not occur within
four seconds, turn off the knob, wait for at least five
minutes to allow any gas to dissipate, then repeat
the test.
Off position
Knob position
indicator
(polished surface)
Burner
designation
Burner Control Knob
Continued...
Logo on front
knob only
Low
position
Area of
operation
Light and high
position
9