Other Functions - Krups Smart'n Light KM6008 Instruction Manual

„ The ground coffee could otherwise block the water circuit.
„ Add 1 spoonful (P) of ground coffee per cup. Do not exceed 10 spoonfuls (70 g). Fig. 9.
„ Close the lid (B).
„ If the coffee maker is in standby, press any button to switch it on.
„ Press the ON/OFF (J) button to start the cycle. The coffee maker beeps and the carafe
symbol is displayed on the screen. Fig. 10.
„ When the cycle is complete, the warm-up feature automatically turns on for 30 minutes.
The carafe symbol remains on the display for the duration of the warm-up period.
„ To stop the coffee maker during the cycle, press the ON/OFF button (J).
Please note:
„ The quantity of coffee in the carafe at the end of the cycle is less than the quantity of water
poured into the reservoir, since the ground coffee and the filter absorb approximately
10% of it.
„ The reservoir is equipped with an overflow opening at the back of the appliance. If you
add too much water, it will come out of this opening.
– DELAYED START (PROG)
Setting the time of the Delayed Start
„ Your appliance features a delayed start program.
„ Make sure that the clock is set to the correct time. If this is not the case, follow the
instructions in the section PROGRAMMING THE CLOCK.
„ Press the PROG button (K) to set the automatic start time. The PROG icon will appear
on the display. Fig. 11.
„ Set the time by pressing the HR button (L) for the hours and MIN (M) button for the
minutes. Fig. 12. The time setting is automatically confirmed after approximately 5
seconds or by pressing the PROG button (K). Fig. 13.
„ Your coffee maker will start automatically at the programmed time. You can view the
programmed time at any time by pressing the PROG button (K).
„ To cancel the delayed start, hold down the PROG (K) button for 3 seconds.
– PRE-INFUSION MODE - AROMA FUNCTION
„ Please note: The AROMA function gets the most from the coffee flavours thanks to the
grind pre-infusion phase.
„ Press the AROMA (N) button before starting the coffee cycle to start the PRE-INFUSION
mode.
„ The AROMA indicator light turns on. Fig. 14.
„ To cancel the PRE-INFUSION mode, press the AROMA (N) button again.
„ To remove the used grounds, remove the filter and filter holder from the coffee maker.
Fig. 15a.
„ Discard the coffee grounds and the filter paper. Fig. 15b.
„ Do not clean the appliance if it is still hot.
„ Wash the removable filter holder using hot soapy water.
CAUTION: Do not put the parts of the coffee maker in the dishwasher.
8

OTHER FUNCTIONS

CLEANING