Programming The Clock; Before Using For The First Time; Coffee Preparation - Krups Smart'n Light KM6008 Instruction Manual

Filter coffee maker

Hide thumbs

Table Of Contents

Table of Contents

Available languages

A Appliance body

B Lid

C Water container

D Water level gauge

E Carafe lid

F Carafe handle

G Carafe

H Heating plate

„ Place the coffee maker on a hard, flat surface.

„ Plug the power cable into a 220V-240V wall outlet.

– When you plug in the coffee maker for the first time, 12:00 AM appears and blinks on the

screen. Fig. 1. Set the hour by pressing the CLOCK button (O), then the HR button (L)

for the hours and MIN (M) button for the minutes. The time appears. It is automatically

confirmed after 5 seconds have elapsed or by pressing the CLOCK button (O).

Note: Your clock is now set and will continue to display the current time even when your

appliance is in standby mode. If you want to set the time again, press the CLOCK (O) button

and repeat the steps above.

If the unit is unplugged or if there is a power failure, the clock will return to 12:00 AM. The

above instructions must be repeated to program the clock again.

BEFORE USING FOR THE FIRST TIME

„ Remove the stickers from the machine.

„ Prior to first use, run your coffee maker without any coffee to rinse the circuit. Fill the

water reservoir up to the maximum level and start a cycle by pressing on the ON/OFF

button (J).

IMPORTANT: Your appliance has been designed to operate using only cold or warm water.

„ Lift the coffee maker's lid (B). Fig. 3.

„ Fill the carafe (G) with cold or warm water. Pour water in the water tank (C) Fig. 4.

„ The number of cups is indicated by marks on the carafe and by the water level indicator.

Do not exceed 10-15 cups. Fig. 5.

„ Place the carafe (G) with its lid (E)closed on the heated base (H) by ensuring that it is

properly in place in order to activate the mechanism that allows the coffee to flow. Fig. 8.

„ Make sure that the filter holder (I) is inserted. Fig. 6. Place the filter paper into the filter

holder (I). Make sure that the filter paper is fully open and properly in place in the filter

holder. Fig. 7.

„ Should some ground coffee be inadvertently poured into the reservoir, refrain from starting

the cycle and first clean the reservoir.

DESCRIPTION