For The Customers In The Uk - Hitachi CM821FET User Manual

CAUTIONS (Continued)

For the Customers in the UK

THIS PRODUCT IS SUPPLIED WITH A 2-PIN MAINS PLUG FOR USE ON MAINLAND
EUROPE. FOR THE UK PLEASE REFER TO THE NOTES ON THIS PAGE.
IMPORTANT FOR UNITED KINGDOM
WORDING FOR CLASS ‡T EQUIPMENT INSTRUCTION BOOKS AND LABELS
The mains lead on this equipment is supplied with a molded plug incorporating a fuse, the
value of which is indicated on the pin face of the plug. Should the fuse need to be replaced,
an ASTA or BSI approved BS 1362 fuse of the same rating must be used. If the fuse
cover is detachable, never use the plug with the cover omitted. If a replacement fuse
cover is required, ensure it is of the same colour as visible on the pin face of the plug.
Fuse covers are available from your dealer.
DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the
power outlets in your home or the cable is too short to reach a power outlet, obtain an
appropriate safety approved extension lead, or consult your dealer.
Changing the mains plug, if necessary, should be carried out by an qualified electrician.
If there is no alternative to cutting off the mains plug, ensure that you dispose of it
immediately, having first removed the fuse, to avoid a possible shock hazard by
inadvertent connection to the mains supply.
WARNING: THIS EQUIPMENT MUST BE GROUNDED
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
Green and Yellow = Ground, Blue = Neutral, Brown = Live.
Green & Yellow to Ground Brown to Live
Fuse
Blue to Neutral Cord Clamp
As these colours may not correspond with the coloured markings identifying the terminals
in your plug, proceed as follows:
The wire which is coloured GREEN and YELLOW must be connected to the terminal in the
plug which is marked with the letter E or by the earth symbol or coloured GREEN or
GREEN and YELLOW.
The BLUE coloured wire must be connected to either N-marked terminal or the BLUE or
BLACK coloured terminal. The BROWN coloured wire must be connected to either
L-marked terminal or the BROWN or RED coloured terminal.
1 - 6