Table of Contents
Advertisement
Heat Dry/Air Dry
Use of the HEAT DRY option, especially in
combination with use of rinse agent, will
enhance drying. If AIR DRY is selected the
heater will be de-activated during the drying
phase of the selected wash cycle. This will
slightly lower the energy use but will increase
the likelihood that the dishware will not dry
completely.
MaxBoost Dry
When MaxBoost Dry
the dishwasher extends drying time by
approximately 20 minutes. The MaxBoost
Dry
option can be used with all cycles except
TM
CHINA CRYSTAL, ENERGY SAVER and RINSE
ONLY. For best drying performance, also apply
an increased wash temperature by selecting
HI-TEMP WASH or even better, the SANITIZE
option.
The energy required to use the MaxBoost
Dry
option costs pennies per cycle. You
TM
may choose not to select the MaxBoost Dry
option; however you may have items in your
dish load that will not be completely dry at the
end of the cycle.
Sanitize Option
To sanitize your dishes and glassware, select
the SANITIZE option. When selected, the
indicator light will come on and remain on until
the end of cycle. The water temperature in
the final rinse will be raised to 156° F
(69° C). This option is available in POWER
PLUS, NORMAL WASH and TOP RACK Cycles.
Only these sanitization cycles have been
designed to meet NSF requirements.
The cycle time will be extended until the
proper water temperature is reached.
Washing action will continue during the water
heating delay. For best results, the incoming
water temperature should be at least 120° F
(49° C).
The sanitize criteria may not be satisfied if
there is an interruption of the cycle, power
failure or if the incoming water temperature is
below 120° F (49° C).
To turn off the SANITIZE option, press
SANITIZE a second time. The indicator light
will turn off.
OPERATING INSTRUCTIONS
TM
option is selected,
TM
Favorite Cycle
The FAVORITE CYCLE option allows you to
program your preferred cycle and options into
one button. Once Programmed, simply select
FAVORITE CYCLE and then select START/
CANCEL.
To Program the FAVORITE CYCLE:
1.
Select your preferred cycle and options
2.
Press FAVORITE CYCLE for 3 seconds.
The display will flash for 2 seconds indicating
the FAVORITE CYCLE option has been
programmed. To change the FAVORITE
CYCLE option simply repeat steps one and
two above.
Delay Start
The DELAY START option allows you to
automatically delay starting your dishwasher
1-24 hours.
To start the DELAY START option, press DELAY
START until the desired delay time shows in
TM
the STATUS window. A light will come on
indicating the delay has been set and will
remain on until cycle starts. Press the START/
CANCEL pad to start the delay option. If the
delay option is interrupted, the START/CANCEL
pad will have to be pressed again to return to
delay option.
To cancel the DELAY START option and to
begin the selected cycle before the
delay period is over, press and hold START/
CANCEL pad for 3 seconds.
To Cancel a Cycle
You can cancel a cycle anytime during the
cycle. Press and hold the START/CANCEL pad
for 3 seconds. The light above the cycle and
option selected will go out, and the START/
CANCEL light will remain illuminated, the
dishwasher will start a 90 second drain. At the
end of the drain, select the next desired cycle.
Child Lock Controls
To prevent children from accidently changing
the dishwasher cycle or starting the
dishwasher, to lock the dishwasher controls
press and hold DELAY START for 3 seconds.
An indicator light on the lock graphic pad will
illuminate when the controls are locked and no
new selections can be made until the lock is
released. To unlock the controls, press DELAY
START again for 3 seconds, and the indicator
light will go out.
5
Advertisement
Table of Contents
