Frigidaire FGID2468UD Use & Care Manual page 18

Table of Contents

Advertisement

BEFORE YOU CALL
Dishwasher Won't Run
Check to see if circuit breaker is tripped
or if a fuse is blown.
Make sure water supply is turned on.
Check to see if cycle is set correctly. (See
Operating Instructions).
Is dishwasher set for Delay Start Option?
Make sure START/CANCEL pad is pressed
after cycle has been selected.
Make sure door is closed and latched
immediately after pressing the START/
CANCEL pad.
Dishwasher Won't Fill
Assure the water supply is turned on.
Check that the overfill protector moves up
and down freely. (See Overfill Protector
section).
Dishwasher Does Not Drain Properly
If unit is hooked up to a food waste
disposer, make sure the disposer is empty.
Assure the knockout plug has been
removed from inside the food waste
disposer inlet.
Assure the drain hose isn't kinked.
Make sure cycle is complete, not in a
pause.
Assure the glass trap is maintained and
installed properly assuring no clogs (See
Care and Cleaning).
Dishwasher has an Odor
Soiled dishes left in dishwasher too long
can create an odor. Use Rinse Only cycle.
There will be a "new" smell when first
installed. This is normal.
Check to see if unit is draining properly.
(See Dishwasher Does Not Drain
Properly).
18
Stains on Tub Interior
Washing large amounts of dishware with
tomato based soil can cause a pink/
orange appearance. This will not affect
performance and will gradually fade over
time. Pre-rinsing or using the Rinse Only
cycle will reduce the chance of staining.
Using no heat dry option will lessen
staining.
Opening the door during cycle
If the dishwasher door is opened while
the unit is running, the START/CANCEL
pad must be pressed and the door shut
immediately to return the unit to the
selected cycle and option, this must
happen within 10 minutes for the unit to
continue the cycle.
Removing Spots and Film
Hard water can cause lime deposit buildup
on the interior of the dishwasher. Dishes
and glasses may also get spots and film for a
number of reasons. (See Glassware/Flatware
Spotted or Cloudy section). To remove
buildup, and film, clean using the following
instructions:
1.
Load clean dishes and glasses in normal
manner. Do not load any metal utensils
or silverware.
2.
Do not add detergent.
3.
Select the NORMAL WASH cycle. Press
START/CANCEL pad. Close the door.
4.
Allow dishwasher to run until it starts
the second water fill (approximately 8
minutes).
5.
Open the door, pour 2 cups of white
vinegar into the bottom of dishwasher.
6.
Press START/CANCEL pad. Close the door
and allow cycle to finish.

Advertisement

Table of Contents
loading

Table of Contents