Connections; Connecting To The Bnc (Ethernet, Power); Connecting Audio; Connecting Alarms - Eneo IEB-72M2812MCA Quick Installation Manual

Connections

Connecting to the BNC (Ethernet, Power)

It is necessary to connect a BNC cable for data transmission and power supply. The
camera must use a dedicated receiver capable of data transmission and power supply
through BNC cable.
NOTE: Joining funcion between receiver and camera is not supported.

Connecting Audio

Connect speaker to audio output line and external mic to audio input line.

Connecting Alarms

AI (Alarm In)
You can use external devices to signal the network camera to react on events. Mechanical
or electrical switches can be wired to the AI (Alarm In) and G (Ground) connectors.
G (Ground)
Connect the ground side of the alarm input and/or alarm output to the G (Ground)
connector.
AO (Alarm Out)
The network camera can activate external devices such as buzzers or lights. Connect the
device to the AO (Alarm Out) and G (Ground) connectors.

Connecting Test Monitor Out (CVBS)

Connect 5pin micro USB test video cable (Optional) to check test video.
8