Removing The Laundry At The End Of The Program; End Of Program/Anti-Crease; Removing The Laundry - Miele TWB 120 WP Operating Instructions Manual

4. Removing the laundry at the end of the program

End of program/Anti-crease

End of program:  lights up and the
Start/Stop sensor button goes out.
After the program has finished, the
drum continues to rotate at intervals for
a max. of 2 hours to reduce creasing.
There is no Anti-crease phase with
Woolens/Silks.
See "Programmable functions", "
Anti-crease".
Energy savings
– 10 minutes after the end of the
program, the Start/Stop sensor
button will begin to flash and the
display will go out.
– The dryer will switch off automatically
15 minutes after the end of the Anti-
crease phase (with programs without
an anti-crease phase, it will switch off
15 minutes after the end of the
program).

Removing the laundry

Only open the door when the drying
process has finished. Otherwise, the
laundry will not be properly dried
through and cooled down.
 Pull the door open at the side with
the orange marker.
 Remove the laundry.
Items left in the dryer could be
damaged by over-drying when the
dryer is used the next time.
Always remove all items from the
drum.
 Turn the program selector to the 
position.
 Remove the lint from the 2 lint filters
in the door opening: see "Cleaning
and care", "Cleaning lint filters".
 Shut the door gently.
 Empty the condensed water
container.
27