Kidde 21027311 User Manual page 18

d. relAx And WAIt
Wait until the new device has connected to the network. Once connected, the
new device will speak, "Success now connected!"
•
Once connected, the light ring will glow green.
e. PICk the InStAlled deVICe
Press and hold the button on the INSTALLED device for 5 SECONDS until you
hear two beeps. Release button. "Sonar" ping will stop.
•
Device will announce that setup is complete and the number of connect-
ed devices.
g. SeleCt loCAtIon And InStAll AlArM.
After selecting the proper location for your alarm, attach the mounting bracket to the wall or ceiling. To ensure aesthetic
alignment of the alarm with the hallway, or wall, the "A" line on the mounting bracket must be parallel with the hallway
when ceiling mounted, or horizontal when wall mounted.
•
Install the alarm fully on the mounting bracket by rotating the alarm in a clockwise direction.
note:
The alarm will mount to the bracket in 4 positions (every 90 degrees).
The alarm is now activated! After installation / activation, test your alarm as described in Operation and Testing section.
WArnIng: fAIlUre to ProPerly InStAll And ACtIVAte thIS AlArM WIll PreVent ProPer
oPerAtIon of thIS AlArM And PreVent ItS reSPonSe to fIre hAzArdS.
18
"Success, now
connected!"
Figure 9.2-D
"Setup
complete!"
Installed Device Added Device
Figure 9.2-E