Table of Contents
Advertisement
ZCVRB60
Fan Kit should be installed before facing material is applied or surround is installed. To remove fan for service, the burner
pan must be removed and work done through the opening (See Burner System Removal section).
TAB
Fan may be installed from left side of fireplace.
NOTE: Do not allow cords or wires to come into contact
with the firebox or the underside of the burner pan.
Electrical Grounding Instructions
This appliance is equipped with a three prong (grounding) plug for your
protection against shock hazard and should be plugged directly into a
properly grounded three-prong receptacle. Do not cut or remove the
grounding prong from this.
Before Servicing:
1.
Ensure all power supply is shut off.
2.
Label all wires prior to disconnecting when servicing control.
Wiring errors can cause improper and dangerous operation.
3.
For fan servicing: Vacuum and clean lint/dirt build-up on the fan
blades and motor.
4.
When resealing the Burner Pan, use Millpac.
Z46FK Fan Kit Installation
TAB
1. Mount fan on tabs
⚠
WARNING
THERMODISC
TAB
2. Connect fan as per
wiring diagram above.
Thermodisc is located on Slider to the right of valve.
To replace pull handle out. Replace Thermodisc. Slide back in.
SLIDER
HANDLE
THERMODISC
Variable
Speed Switch
In unit location
for Variable
Speed Switch
Variable Speed
Switch may be
installed
through existing
3/8" hole in side
frame of
fireplace.
34
Advertisement
Table of Contents
