Rigol DS7000 Series Quick Manual page 20

RIGOL
(1) Turn off the instrument and remove the power cord.
(2) Insert a small straight screwdriverinto the slot at the power cord
connectorand pry out the fuse holder gently.
(3) Take out the fuse and replace it with a specified fuse. Then,install the fuse
holder.
5． AC PowerCord Connector
AC power input terminal. The power requirements of this oscilloscope
are100-240 V, 45-440 Hz. Use the power cord provided with the accessories to
connect the instrument to AC power. Then, you can press the Power key onthe
front panel to start the instrument.
6． Lock Hole
You can lock the instrument to a fixed location by using the security lock (please
purchaseit yourself) via the lock hole.
7． Trigger Out
The oscilloscope can output a signal that can reflect the current capture rate of
the oscilloscope at each trigger via this interface. Connect the signal to
awaveform display device and measure the frequency of the signal. The
measurement result is the same asthe current capture rate. The instrument can
also outputa signalwhen a failed waveform is detected during the pass/fail test.
8． Source Output
When Source1 or Source2 is enabled, thesignal currently set can
beoutputthrough the [Source1]or[Source2]connectoron the rear panel to the
analog input terminal of the oscilloscope or external devices connected to the
connector. This function is only available for the MSO2000A-S model.
10
MSO2000A/DS2000A Quick Guide