Table of Contents
Advertisement
Remove the RAM Module from DiskStation
1 Follow step 1 to 3 of the "Install the RAM Module" section to reveal the motherboard of your DiskStation.
2 Remove the RAM module.
a Open the ejectors on the memory slot and push them out to the sides.
b Hold the memory module by its notches and remove it from the slot.
3 Follow step 5 to 6 of the "Install the RAM Module" section to replace the inner panel and the covers of your
DiskStation.
Add a Network Interface Card on DiskStation
Your DiskStation has a PCI Express expansion slot which allows you to install 10G/E or Gigabit network interface
card for LAN port expansion.
with the short bracket before installing the card on your DiskStation.
To replace the long bracket with the short one:
1 Unscrew the 2 screws in the long bracket on your network interface card, and then remove the bracket.
2 Replace the long bracket with the short one, and tighten the 2 screws to secure the short bracket.
---------
1
For more information about supported 10G/E or Gigabit network interface cards, visit www.synology.com.
13 Chapter 2: Hardware Setup
1
You need to replace the long bracket (suited for PC) in your network interface card
Advertisement
Table of Contents
