FMI VTDGT24NR Manual page 14

Burner Tube
Figure 23A - Installing Middle Split Log Rear Top Side
6. Find the right split crossover log (D-022) The bottom of
the log has a rectangular stand off that fits in the slots on
the right side of the front right log and the middle split log.
Place this log as shown in Figure 24.
Square Peg
Right Front Log
Figure 24 - Installing Right Split Crossover Log
7. Find the front top log (D-024). See Figure 25. The left end
of this log has a square hole that fits over a square peg that
is on the top of the middle split log. The right end of this log
rests behind the knot on the top of the front right log.
Front Top Log
(D-024)
Middle Split Log
Figure 25 - Installing Front Top Log
14
INSTALLATION
Log Notch
View
Right Split Crossover
Log (D-022)
Right Split
Crossover
Rectangular
Log (D-022)
Peg
www.fmiproducts.com
Continued
8. Find the back top log (LMF36-SC and VFGT24 inch
models: D-062 or LMF42-SC and VFGT30 inch models:
D-023 or LMF48-SC and VTGF36 inch models: D-029).
See Figures 26, and 26A. The left end of this log has a
round hole that fits over the round peg that is on the top
of the back left log. The right end of this log has a rectan-
gular hole that fits over the rectangular peg on the top of
the right crossover log.
Back Top Log (D-062,
D-023 or D029)
Figure 26 - Installing Back Top Log and Final Assembly
Figure 26A - Installing Back Top Log, Top View
LAVA ROCK PLACEMENT
Place lava rock around the base of the burner assembly on
the fireplace floor to simulate an ash bed. Do not place lava
rock or any other material on the burner.
Right Split
Crossover
Log (D-022)
125598-01D