FMI VTDGT24NR Manual page 11

Control
Valve
Figure 17- Disconnecting Switch from Control Valve
MF SERIES BURNER SYSTEM-LOG COMPATIBILITY
Burner System Model
MF42ONR,MF42OPR,
MF48ONR, MF48OPR,
Figure 18 - MF Series Burner System- Log Compatibility
INSTALLING LOGS AND LAVA ROCK
WARNING: Failure to position the parts in
accordance with these diagrams or failure to
use only parts specifically approved with this
appliance may result in property damage or
personal injury.
CAUTION: After installation and periodically
thereafter, check to ensure that no flame comes
in contact with any log. With appliance set to
Hi, check to see if flames contact any log. If
so, reposition logs according to log installation
instructions in this manual. Flames contacting
logs will create soot.
125598-01D
INSTALLATION
Switch
CHART
Refractory Concrete Logs
For Use With This Burner
System
LMF36-SC
LMF42-SC
LMF48-SC
Chart
www.fmiproducts.com
Continued
It is very important to install these logs exactly as instructed.
Do not modify logs. Only use logs supplied with appliance or
as identified for use with the appliance as shown in Figure 18.
Note: Each log includes an identifying number cast in the log.
Look at each log when placing them on the burner system to
be certain it is correct.
Note: For additional information, go to www.fmiproducts.com
and click on the technical Support tab for access to log place-
ment videos.
1. Find the right front log (LMF36-SC and VFGT24 inch
models: D-061 or LMF42-SC and VFGT30 inch models:
D-019 or LMF48-SC and VFGT36 inch models: D-027).
See Figures 19, 19A, 19B, and 19C for reference. The log
has a rectangular shape on the bottom that fits against the
lip on the black metal base, the square grate, and the round
tube burner. Slide the log in place as shown in Figures.
Burner
Tube
Grate Finger
Figure 19 - Installing Right Front Log
Grate Finger
Figure 19A - Installing Right Front Log, Top View
LOG PLACEMENT
Right Front Log (D-061,
D-019 or D027)
Round Tube
Burner
11