Report? (Query Only; Sett - Tektronix DS1000 Series User Manual

Appendix B: Remote Control

REPORT? (Query only)

Requests the operating state of the television demodulator. The
response is 0 when an active input signal is detected and 2 when no
signal is detected. The television demodulator must be in the remote
state to use this command.
Syntax
REPORT? <tic_state>
Arguments
<tic_state> one byte, either 0 to indicate an active signal, or 2 to
indicate no input signal.
Examples
Command
`REPORT?'

SETT

Sets or requests several operating parameters of the television
demodulator. With the SETT command, you can set several
parameters at once instead of using several different commands. SETT
can replace the following commands: FREQ, AFC, AUD_PREF,
STRAP, ZCP, BTSC and AUD_OUT. The new settings are effective
immediately. The television demodulator must be in the remote state
to use this command.
Syntax
SETT=<settings_data>
SETT?
Arguments
<setting_data>
B–26
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Result
2
The television demodulator does not detect a signal.
DS1000 Series User Manual