Table of Contents
Advertisement
which depend on the station's MAC addresses.
MAC Address - The wireless station's MAC address that you want to access.
Status - The status of this entry either Enabled or Disabled.
Privilege - Select the privileges for this entry. You may select one of the following Allow / Deny /
64-bit / 128-bit / 152-bit.
Description - A simple description of the wireless station.
WEP Key - Specify a unique WEP key (in Hexadecimal format) to access the router.
To set up an entry, follow these instructions:
First, you must decide whether the unspecified wireless stations can access the router or not. If you
desire that the unspecified wireless stations can access the router, please select the radio button Allow
the stations not specified by any enabled entries in the list to access, otherwise, select the radio
button Deny the stations not specified by any enabled entries in the list to access.
To Add a Wireless MAC Address filtering entry, click the Add New... button. The "Add or Modify
Wireless MAC Address Filtering entry" page will appear, shown in Figure 4-19:
Figure 4-19 Add or Modify Wireless MAC Address Filtering entry
To add or modify a MAC Address Filtering entry, follow these instructions:
1.
Enter the appropriate MAC Address into the MAC Address field. The format of the MAC Address is
XX-XX-XX-XX-XX-XX (X is any hexadecimal digit). For example: 00-0A-EB-B0-00-0B.
2.
Enter a simple description of the wireless station in the Description field. For example: Wireless
station A.
3.
Privilege - Select the privileges for this entry, one of Allow / Deny / 64-bit / 128-bit / 152-bit.
4.
WEP Key - If you select 64-bit, 128-bit or 152-bit in the Privilege field, enter any combination of
hexadecimal digits (0-9, a-f, A-F) in the specified length. For example: 2F34D20BE2.
5.
Status - Select Enabled or Disabled for this entry on the Status pull-down list.
6.
Click the Save button to save this entry.
MR5-WR542G
54Mbps Wireless Router User Guide
33
Advertisement
Table of Contents
