Installation - Zanussi ZGG65414SA User Manual

• Disconnect the appliance from the elec-
trical supply, before you do the mainte-
nance work or you clean it.
• The electrical mains terminal is live.
• Make electrical mains terminal free of volt-
age.
• Install correctly to give anti-shock protection.
• A loose and incorrect mains plug and socket
connections can make the terminal become
too hot.
• A qualified electrician must install the clamp-
ing connections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains connection cable and
replace the damaged mains cable with appli-
cable cable. Speak to your local Service
Force Centre.
• The appliance must have the electrical instal-
lation which lets you disconnect the appli-
ance from the mains at all poles with a con-
tact opening width of minimum 3 mm.

Installation

Warning! The following instructions about
installation, connection and maintenance
must be carried out by qualified personnel in
compliance with standards and local
regulations in force.
Important safety requirements
This hob must be installed in accordance with
the Gas Safety (Installation and Use) Regula-
tions (Current Edition) and the IEE Wiring Reg-
ulations (Current Edition).
For appliances installed in the Republic of Ire-
land please refer to NSAI- Domestic Gas In-
stallation I.S. 813 Current Editions and the ET-
CI Rules for Electrical Installations.
Provision for ventilation
Detailed recommendations are contained in the
following British Standards Codes Of Practice:
B.S. 6172/ B.S. 5440, Par. 2 and B.S. 6891
Current Editions.
The hob should not be installed in a bed sitting
room with a volume of less than 20 m³. If it is
installed in a room of volume less than 5 m³ an
4
• If the fixing bracket is near to the terminal
block, always make sure the connection ca-
ble does not come in contact with the edge
of the bracket.
• You must have correct isolation devices: line
protecting cut-outs, fuses (screw type fuses
removed from the holder), ground leakage
trips and contactors.
Disposal of the appliance
• To prevent the risk of physical injury or dam-
age
– Disconnect the appliance from the power
supply.
– Cut off the mains cable where it connects
with the appliance and discard it.
– Flat the external gas pipes if there are fit-
ted.
– Speak to your local authorised facilities for
disposal of your appliance.
air vent of effective area of 100 cm² is required.
If it is installed in a room of volume between 5
m³ and 10 m³ an air vent of effective area of 50
cm² is required, while if the volume exceeds 11
m³ no air vent is required.
However, if the room has a door which opens
directly to the outside no air vent is required
even if the volume is between 5 m³ and 11 m³.
If there are other fuel burning appliances in the
same room, B.S. 5440 Part 2 Current Edition,
should be consulted to determine the requisite
air vent requirements.
For appliances installed in the Republic of Ire-
land please refer to the NSAI- Domestic Gas
Installation I.S. 813 Current Editions Table
Four.
Location
The hob may be located in a kitchen, a kitchen/
diner or bed sitting room (with a volume greater
than 20 m³), but not in a bathroom or shower
room.
The minimum distance combustible material
can be fitted above the hob in line with the
www.zanussi.com