Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi GAS HOB ZGG 659
Summary of Contents for Zanussi GAS HOB ZGG 659
-
Page 1: Gas Hob
GAS HOB ZGG 659 INSTRUCTION BOOKLET... -
Page 2: Important Safety Information
Important Safety Information You MUST read these warnings carefully before installing or using the appliance. Installation This appliance must be installed by qualified personnel, according to the manufacturer’s instructions and to the rules in force. Remove all packaging before using the appliance. -
Page 3: Table Of Contents
Contents For the User Description of the Appliance Operation Maintenance and Cleaning Something Not Working? Guide to Use the instructions The following symbols will be found in the text to guide you throughout the Instructions: For the Installer Page Engineers Technical Data Page Installation Page... -
Page 4: Description Of The Appliance
Description of the Appliance 1. Hob Top 2. Rapid Burner 3. Semi-rapid Burners 4. Auxiliary Burner 5. Control knob for back right burner (semi-rapid) 6. Control knob for back left burner (semi-rapid) 7. Control knob for front left burner (rapid) 8. -
Page 5: Operation
Operation Hob burners control knobs The symbols on the hob burners control knobs mean that: there is no gas supply there is maximum gas supply there is minimum gas supply Lighting the burners For easier lighting, proceed before putting a pan on the pan support. To light a burner: Push in the relevant knob and turn it anticlockwise to "maximum position". -
Page 6: Maintenance And Cleaning
Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. The Hob Top Regularly wipe over the hob top and the aluminium frame using a soft cloth well wrung out in warm... -
Page 7: Something Not Working
Something Not Working? If the appliance is not working correctly, please carry out the following checks before contacting your local Service Centre. SYMPTOM There is no spark when lighting the gas The gas ring burns unevenly If after all these checks, your appliance still does not operate correctly, contact your local Service Centre. Instructions for the Installer Engineers technical data OVERALL DIMENSIONS... -
Page 8: Installation
Installation IMPORTANT This appliance must be installed by qualified personnel. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored. Gas Connection On the end of the shaft (A) , which includes the GJ 1/2"... -
Page 9: Building In
Building in Building over a cupboard or drawer If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. Building over a kitchen unit with door Proper arrangements must be taken in designing... -
Page 10: Fitting The Hob To The Worktop
the worktop Before fitting the hob into the cut out, an adhesive seal must be fitted to the underside outside edge (see figure 6) of the hob. It is essential that no gaps are left in this seal in order to prevent spillage near the hob seeping into the cabinet below. -
Page 11: Commissioning
Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - Turn the gas tap to the MAX position and ignite. - Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times.