Table of Contents
Advertisement
1
5
Green and Yellow
1
3 amp fuse
2
Brown
3
Cord clamp
4
Blue
5
Should the plug need to be replaced for any
reason, the wires in the mains lead are coloured
in accordance with the following code:
Green and yellow
Blue
Brown
1. Connect the green and yellow (earth) wire
to the terminal in the plug which is marked
with the letter 'E' or the earth symbol
or coloured green and yellow.
2. Connect the blue (neutral) wire to the ter-
minal in the plug which is marked with the
letter 'N' or coloured black.
3. Connect the brown (live) wire to the termi-
nal in the plug which is marked with the let-
ter 'L' or coloured red.
There must be no cut or stray strands of wire
present. The cord clamp must be secured on
the outer sheath.
Warning! Make sure that the cut off plug
is disposed of safely. A cut off plug put
into a 13 amp socket is a safety hazard. There
is a risk of electrical shock.
www.zanussi.com
2
3
4
- Earth
- Neutral
- Live
Important! The replacement of the electrical
cable must be done by a qualified electrician or
competent person, according to the current
regulations.
Replacement of the connection cable
To replace the connection cable use only
H05V2V2-F T90 or equivalent type. Make sure
that the cable section is applicable to the volt-
age and the working temperature. The yellow/
green earth wire must be approximately 2 cm
longer than the brown (or black) phase wire.
Building In
min. 55 mm
10 mm
,
A) supplied seal
B) supplied brackets
Possibilities for insertion
Kitchen unit with door
The panel installed below the hob must be easy
to remove and let an easy access in case a
technical assistance intervention is necessary.
min. 100 mm
min. 650 mm
30 mm
560 mm
3 mm
11 mm
B
A
11 mm
A
7
Advertisement
Table of Contents
