Monte Carlo Fan Company 3AKR56 D Series Owner's Manual And Installation Manual page 3

1
Before you begin installing the fan, Switch
power off at Service panel and lock
service disconnecting means to prevent
power from being switched on
accidentally. When the service
disconnecting means cannot be locked,
securely fasten a warning device, such
as a tag, to the service panel.
Use AC 120V/60HZ power supply
only.
4
Set screw
Install blade supporting ring onto the
blades with screws provided. Do not over
tighten.
Note: For easy assembling and avoiding
blade damage from scratch, put blades
on a suitable place of Styrofoam.
© 2018 Monte Carlo Fan Company
2
Before installing this fan make sure the
outlet box is properly installed to the
house structure. To reduce the risk of
fire, electric shock, or personal injury,
mount to outlet box or supporting system
acceptable for fan support.
(Mounting must support at least 35 lbs.)
5
Blade assembly
Blade supporting
ring
Blade
Flick the blade assembly over and place it
on motor.
Note: For easy assembling and avoiding
blade damage from scratch, put blades
on a suitable place of Styrofoam.
3
Use metal outlet box suitable for fan
support and use only the screws provided
with the outlet box (must support 35 lbs).
Before attaching fan to outlet box, ensure
the outlet box is securely fastened by at
least two points to a structural ceiling
member (a loose box will cause the fan to
wobble). Remove the two outlet box
screws provided with the box, aligning
the holes of the mounting bracket with
the holes of the outlet box. Reinstall the 2
outlet box screws securely.
6
Motor
Align the holes as shown in graphic and
install blade assembly onto motor with
set screws provided. Tighten set screws
securely. Do not over tighten.
3
Mounting bracket
05/2018