Table of Contents
Advertisement
WPS B
UTTON
R
P
EAR
ANEL
W
A
IRELESS
NTENNAS
P
OWER
Table 2: LED Behavior (Continued)
LED
Status
WAN
On
LAN (1-4)
Blinking
Off
WPS
On
Slow Blinking
Off
Push this button to start WPS authentication of a wireless device. Push and
hold down this button for more than 5 seconds to reset the unit.
After a device is successfully added to the network by WPS, the WPS
N
:
OTE
LED will remain on for about 5 minutes and then turn off. When press and
hold the WPS Button for more than 5 seconds, you will reset the router.
Figure 2: Rear Panel
The following items are located on the rear panel (from left to right).
Receives and transmits wireless data.
The Power socket is where you connect the power adapter. Use the power
adapter provided with the Router.
– 27 –
C
HAPTER
Description
There is a device linked to the corresponding port, but
there is no activity.
There is an active device linked to the corresponding
port.
There is no device linked to the corresponding port.
A wireless device has been successfully added to the
network by WPS. The LED will remain on for about 5
minutes.
A wireless device is connecting to the network by
WPS. This process lasts for about 2 minutes.
WPS is not in progress.
| Introduction
1
Rear Panel
Advertisement
Table of Contents
