Midea 1234G1A Instruction Manual page 21

How to remove and install the
Warning:Before remove and install the
appliance from the power supply.
1 hands with oil blockage ,pressed on the arrow
shown,pushed back slamly,then pulling down.
2.status of remove
3.taking oil blockage from the appliance.
Splash shield cleaning
1. Detaching: Hold the two
hands (as shown by the arrows).
the arrows and pull downwards after you have pulled out the
2. Wash ,rinse and sanitize
3. Installation: Pick up the splash shield and obliquely put it into the chamber at a
slight angle in the way that insert the first pin at the rear into the positioning hole
on the rear plate of chamber, then push the other side to insert all positioning pins
into their positioning holes.
ceiling plate
thumb pressed here
tabs on the
Push tabs
the splash shield:
ceiling plate
1.Hands to take the oil blockage,,after
alignment three cylinder of the oil blockage,
inserting the three holes of the back plate.
2.The left hand grasp the microwave, right thumb to
press the arrow directions and forced to push back.
And the leftthumbhardpressed upwordatthe
sametime. put the right of oil blockage into
the buckle of the feont plate.
3.From right to left, make the oil blockage loaded.
When finish, check to ensure that the oil blockage
buckle completely go.
front of the splash shield with your
following the direction of
20
,be sure to unplug the
thumb pressed here
tab s: