Electrical Warnings And Cautions - General International DP2002 Setup & Operation Manual

SPEED SETTING OF THE DRILL PRESS.
This drill press has 5 spindle speeds. Check spindle speed setting of
the drill press based on pulley speed chart located inside the pulley
housing. Ensure accessories used have a higher speed rating than the
current spindle speed setting of the drill press. Accessories running
faster than rated speed can fly apart and cause injury.
38. DO NOT INSTALL OR USE DRILL BITS THAT EXCEED 7"
(18 cm) in length or extend 6" (15 cm) below the chuck jaws. They can
suddenly bend outward or break.
39. DO NOT USE WIRE WHEELS, ROUTER BITS, SHAPER
CUTTERS, CIRCLE (FLY) CUTTERS, OR ROTARY PLANERS
on this drill press.
40. AVOID AWKWARD OPERATIONS AND HAND POSITIONS.
A sudden slip could cause a hand to move into the bit.
41. NEVER PERFORM LAYOUT, ASSEMBLY, OR SET-UP WORK ON
THE TABLE
/work area when the machine is running. A sudden slip could cause a
hand or hair to move into the spinning bit or chuck. Severe injury can
result.
42. DO NOT GET DISTRACTED AND ALWAYS CONCENTRATE ON
WHAT YOU ARE DOING.
Use common sense. Never operate the machine when you are tired,
sick, or under the influence of alcohol, or other drugs.
43. TURN THE MACHINE OFF,
disconnect the machine from the power source and clean the table /
work area before leaving the machine.
44. LOCK THE SWITCH IN THE "OFF" POSITION TO PREVENT
UNAUTHORIZED USE.
Someone else might accidentally start the machine and cause injury to
themselves.
45. KEEP THESE INSTRUCTIONS.
Refer to them frequently and use them to instruct other users. If you
lend someone this unit, also lend them the instructions.
46. FAILURE TO FOLLOW OPERATING INSTRUCTIONS AND
SAFETY PRECAUTIONS IN THIS INSTRUCTION MANUAL CAN
RESULT IN SERIOUS INJURY.
Read the manual before starting or operating this unit.
47. KEEP THESE INSTRUCTIONS.
Refer to them frequently and use them to instruct other users. If you
loan someone this unit, also loan them the instructions.
CALIFORNIA PROPOSITION 65
This product or its power cord may contain chemicals, including lead,
known to the State of California to cause cancer and birth defects or other
reproductive harm. Wash hands after handling.
Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities contain chemicals known to cause cancer, birth
defects or other reproductive harm. Some examples of these chemicals are:
─Lead from lead-based paints
─Crystalline silica from bricks and cement and other masonry products
─Arsenic and chromium from chemically-treated lumber
Your risk from these exposures varies, depending on how often you do
this type of work. To reduce your exposure to these chemicals, work in a
well ventilated area, and work with approved safety equipment,
such as those dust masks that are specially designed to filter out
microscopic particles.
WEAR PROTECTIVE GEAR.
ELECTRICAL
WARNINGS AND CAUTIONS
1. BEFORE CONNECTING THE MACHINE to the power source, verify
that the voltage of your power supply corresponds with the voltage
specified on the motor I.D. nameplate. A power source with greater
! WARNING !
170207
9