Alpine 9ZUA148 Manual page 35

Radio Antenna Receptacle
GPS Antenna Receptacle
Connect to GPS antenna (Included).
Speed Sensor Lead (Green/White)
Improper connection of the speed pulse line may cause
important safety features of the vehicle to fail (such as the
brakes or air bags). Such failures may result in an accident
and loss of life. We strongly recommend that the installation
be performed by a trained, authorized Alpine dealer.
CAMERA Input Connector
iDataLink Interface Connector
To iDataLink module.
Video/Audio (R,L) Input Connector (AUX INPUT)
Input the AUX Video/Audio (R,L).
• When you use this connector, an optional AV/RCA interface cable
should be used.
Usable AV/RCA interface cable (4-pole mini AV plug
to 3-RCA)
Wiring convention of this system is as follows:
Audio L (White)
Audio R (Red)
Ground
Video (Yellow)
Yellow
Red
White
• Configuration commercially available 4-pole mini AV plugs is not
standardized.
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
Reverse Lead (Orange/White)
Connect to the plus side of the car's reverse lights. These
lights illuminate when the transmission is shifted into reverse
(R).
With this lead properly wired, the video picture
automatically switches to the rear camera whenever the car
is put into reverse (R).
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna,
if applicable.
• This lead should be used only for controlling the vehicle's
power antenna. Do not use this lead to turn on an amplifier or a
signal processor, etc.
Parking Brake Lead (Yellow/Blue)
Connect this lead to the power supply side of parking brake
switch to transmit the parking brake status signals to the
unit.
Video input
terminal
Audio input
terminal
(R,L)
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's fuse
box or another unused power source that provides (+) 12V
only when the ignition is turned on or in the accessory
position.
Fuse Holder (15A)
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle's
battery.
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
Left Rear (+) Speaker Output Lead (Green)
Left Rear (–) Speaker Output Lead (Green/Black)
Left Front (+) Speaker Output Lead (White)
Left Front (–) Speaker Output Lead (White/Black)
Right Front (–) Speaker Output Lead (Gray/Black)
Right Front (+) Speaker Output Lead (Gray)
Right Rear (–) Speaker Output Lead (Violet/Black)
Right Rear (+) Speaker Output Lead (Violet)
Steering Remote Control Interface Connector
To steering remote control interface box.
For details about connections, consult your nearest Alpine
dealer.
MIC Input Connector
To microphone (Included)
Front Output RCA Connectors
Can be used as Front Output RCA Connectors. RED is right
and WHITE is left.
Rear Output RCA Connectors
Can be used as Rear Output RCA Connectors. RED is right
and WHITE is left.
Subwoofer RCA Connectors
RED is right and WHITE is left.
CAN I/F Connector
USB Connector
To iphone 5 or later.
Power Supply Connector
W.REMOTE Connector
PRE OUT Connector
35
-EN