Error Mode - LG FH069FDFS Owner's Manual

78

ERROR MODE

ERROR MODE
Meaning of Error Codes that LED displays during occurrence of problem.
Problem
• Water supply is not adequate in area.
• Water supply taps are not completely open.
• Water inlet hose is bent.
• The filter of the inlet hose clogged.
• Drain hose is bent
• The drain filter is clogged.
• Load is too small.
• Load is out of balance.
• The appliance has an imbalance detection and
• Is the door opened or not completely
• Door lock is broken.
• The water overfills due to a faulty water
• The water level sensor malfunction.
• Overload in motor.
• Disconnection of card reader cable.
• Too much detergent is used.
• Malfunction in Heater system.
Possible Cause
or clogged.
correction system. If individual heavy articles
are loaded (bath mat, bath robe, etc.) and the
imbalance is too great, after several attempts to
restart the spin cycle the machine will stop and
the error code will be displayed.
closed?
valve.
• Thermistor is opened or shorted.
Solution
Check another tap in the house.
Fully open tap.
Straighten hose.
Check the filter of the inlet hose.
Clean and straighten the drain
hose.
Clean the drain filter.
Add 1~2 similar items to help
balance the load.
Rearrange load to allow proper
spinning.
Close the door completely.
✽ If it will not open, call for service.
Check the door switch.
Close the water tap.
Unplug the power plug.
Call for service.
Restart the cycle after 30 minutes.
If is not released, call for
service.
Check the card reader wire.
This is not an error. It indicates a
suds removal routine.
It will clear and restart the cycle
when the suds are gone.
Thermistor should be replaced.
Check the heater and wire.