Table of Contents
Advertisement
ERROR MODE
Meaning of Error Codes that LED displays during occurrence of
problem.
Problem
• Water supply is not adequate in area.
• Water supply taps are not completely
open.
• Water inlet hose is bent.
• The filter of the inlet hose clogged.
• Drain hose is bent
or clogged.
• The drain filter is clogged.
• Load is too small.
• Load is out of balance.
• The appliance has an imbalance
detection and correction system. If
individual heavy articles are loaded (bath
mat, bath robe, etc.) and the imbalance
is too great, after several attempts
to restart the spin cycle the machine
will stop and the error code will be
displayed.
• Is the door opened or not completely
closed?
• Door lock is broken.
• The water overfills due to a faulty water
valve.
• The water level sensor malfunction.
• Overload in motor.
• Disconnection of card reader cable.
• Too much detergent is used.
• Thermistor is opened or shorted.
Possible Cause
Solution
Check another tap in the house.
Fully open tap.
Straighten hose.
Check the filter of the inlet hose.
Clean and straighten the drain hose.
Clean the drain filter.
Add 1~2 similar items to help
balance the load.
Rearrange load to allow proper spinning.
Close the door completely.
✽ If it will not open, call for service.
Check the door switch.
Close the water tap.
Unplug the power plug.
Call for service.
Restart the cycle after 30 minutes.
If
is not released, call for service.
Check the card reader wire.
This is not an error. It indicates a suds
removal routine.
It will clear and restart the cycle when
the suds are gone.
Thermistor should be replaced.
75
ERROR MODE
Advertisement
Table of Contents
