Connecting The Water Lines - LG FH069FDFS Owner's Manual

Connecting the water lines

1
Check the rubber seals on both sides of the
hose.
- Insert a rubber seal into the threaded
fittings on each hose to prevent leaking.
Rubber seal
Water hose
(To water inlet on the
washing machine)
2
Connect the water supply hoses to the HOT
and COLD water faucets tightly by hand and
then tighten another 2/3 turn with pliers.
- Connect the blue hose to a cold water
faucet and the red hose to a hot water
faucet.
WARNING
• Do not overtighten. Damage to the cou-
pling can result.
3
After connecting inlet hose to water faucets,
turn on the water faucets to flush out foreign
substances (dirt, sand or sawdust) in the
water lines. Let water drain into a bucket,
and check the water temperature.
4
Rubber seal
Water hose
(To faucet)
• Do not overtighten the hoses.
5
• For your safety, and for extended product
• Use new hoses when you install the washing
• Periodically check the hoses for cracks, leaks
• Do not stretch the water hoses intentionally,
•
• To provide optimum washing performance
INSTALLATION INSTRUCTIONS
Connect the hoses to the water inlets tightly
by hand and then tighten another 2/3 turn
with pliers.
- Connect the blue hose to the cold water
inlet and the red hose to the hot water
inlet.
Cold water
inlet
WARNING
Overtightening can damage the valves
resulting in leaking and property damage.
Check for leaks by turning on the faucets.
- If water leaks, check steps 1 to 4 again.
NOTE
life, use only authorized components. The
manufacturer is not responsible for product
malfunction or accidents caused by the use
of separately purchased unauthorized parts.
machine. Do not reuse old hoses. Use only
the inlet hoses provided with the washer. LG
does not recommend the use of aftermarket
hoses.
and wear, and replace the hoses every 5
years.
and make sure that they are not crushed by
other objects.
Water supply pressure must be
between 1.0 kgf/cm² and 10.0 kgf/
cm² (100~1000 KPa). If the water
supply pressure is more than 10.0
kgf/cm², a pressure reducing valve
must be installed.
the hot water temperature should be set at
120-135°F (48-57°C) and the cold at 60°F
(15°C).
15
Hot water
inlet