Hyundai TG1000i Manual page 49

GENERATOR USE
1. Connect the ground terminal
2. Start each engine according to "STARTING THE ENGINE".
When the output indicator light (green) does not light and the overload indicator light (red) lights
instead, set the engine switch to STOP, stop the engine at once and then start the engine again.
3. Confi rm that the equipment to be used is switched off, and insert the plug of the equipment to
be used into the AC receptacle.
CAUTION
■Confi rm that the use equipment to be connected is switched off.
■When the equipment to be used is switched on, it will operate
suddenly, and injuries or accidents may be caused.
CAUTION
When equipment requiring a large starting power, like a motor etc.,
is used, the overload indicator light (red) and the output indicator
light (green)may light together for a short time (about 4 sec), but this
is no abnormality. After start of the equipment, the overload indicator
light (red) will go out and the output indicator light (green) will stay lit.
ENGLISH
49