Trou Ble Shooting - Telex RadioCom BTR-800-H1 Operating Instructions Manual

Re read the sec tions of this manual to make sure you have
com pleted sys tem set-up prop erly.
PROBLEM
DISTORTION - System's audio quality seems distorted
at medium to high input levels.
HISS - System seems to produce a "hiss" which is
undesirable.
LOW OUTPUT - System produces a low output level.
FEEDBACK - Moving around area of use produces
"squeal" or "howl" in various locations using ext.
speakers.
DROPOUTS - When moving around the area of use there
seems to be locations where the signal "swooshes" or
completely disappears.
INTERFERENCE - System picks up signals other than
wireless intercoms.
NO AUDIO from BASE or BELTPACK headsets.
If you are un able to solve the prob lem, con tact the dealer from
whom you purchased the sys tem for as sis tance.
Reduce microphone gain by adjusting microphone gain
control.
Check the gain setting on all beltpacks and the base. They
may be too low or too high. Check to make sure you are
still well within range of the base station.
Check the gain setting on both the beltpacks and the base.
They may be too low.
Reduce the gain settings on both the beltpacks and the
base. They may be too high.
Make sure both antennas on the base and beltpack are
connected and follow the location suggestions. Change the
location of the base unit and antennas or avoid the bad
areas with the remote beltpacks.
Make sure that all the Telex beltpack(s) are on. If there are
any unused receivers at the base, turn the audio off from
those receivers by deselecting the appropriate "Portable
Station Connect" button.
If problems persist with the beltpack on, you will probably
need to change the group. Make sure the base and
beltpack match after any Group/Channel change.
Check Transmitter switch on base and beltpack. Check
talk LED to make sure it is on. Make sure beltpack
batteries are OK.
9-1
S

Trou ble shooting

SOLUTION
ection
9