Gestetner DSm651 Network Manual page 44

Connecting and Setting Up
❖ ❖ ❖ ❖ Domain Name
Make settings for the domain
name.
• Auto-Obtain (DHCP)
• Specify
• Domain Name
2
❖ ❖ ❖ ❖ WINS Configuration
You can specify the WINS server
settings.
• On
If [On] is selected, specify the
[V V V V WINS Server] IP address as
"xxx.xxx.xxx.xxx" ("xxx" indi-
cates a number).
If DHCP is in use, specify the
[Scope ID].
• Primary WINS Server
• Secondary WINS Server
• Scope ID
• Off
Limitation
❒ Enter [Scope ID] using up to 31
alphanumeric characters.
Note
❒ Default: Off
❖ ❖ ❖ ❖ IP over 1394
When you use the IP over 1394
function of the IEEE 1394 interface
to connect the machine to the net-
work, or you print from computer
with the IP over 1394 driver, you
must specify [Active]for [IP over
1394].
• Active
• Inactive
Limitation
❒ Printing with IP over 1394 is pos-
sible under Windows Me/XP
and Windows Server 2003
Note
❒ Default: Active
38
❖ ❖ ❖ ❖ SCSI print (SBP-2)
When you print using the SCSI
print client function supported by
Windows 2000/XP, or Windows
Server 2003, you must set [SCSI
print (SBP-2)].
• Active
• Inactive
Limitation
❒ The IEEE 1394 interface can be
used when Windows 2000 Serv-
ice Pack 1 or later is installed. If
the Service Pack is not installed,
only one SCSI print device is
connectable via 1394 bus.
Note
❒ Default: Active
❖ ❖ ❖ ❖ Bidirectional SCSI print
Specifies the printer's response
mode etc. for status requests when
using the IEEE 1394 interface.
• On
• Off
Note
❒ Default: On
❒ If this is set to [Off], bidirectional
communication will not work.