Programming An End Receiver - Gestetner DSm616 Facsimile Reference Manual

Note
❒ An e-mail address can be set as the
forwarding destination.
❒ If you do not program an End Re-
ceiver, the machine performs
printing but not forwarding even
with the Forwarding function On.
❒ You can program one of the User
Function keys with operations for
this function. You can then switch
the function on or off merely by
pressing the User Function key.
❒ If you want to change End Receiv-
ers separately according to send-
ers, specify End Receivers for each
special sender in "Special Senders
to Treat Differently". You can pro-
gram one receiver per Special
Sender. Received messages from
unspecified senders will be for-
warded to the End Receiver speci-
f i e d h e r e . S e e p . 8 9 " S p e c i a l
Senders to Treat Differently".
❒ One receiver only can be specified
using this function. For multiple
receivers, use Group Dial.
❒ You can specify whether or not to
print forwarded messages. See
p.80 "User Parameters" (switch 11,
bit 6).
❒ Deleting a destination specified as
an end receiver from the Address
Book causes the settings for the
end receiver to be deleted. If this is
the case, reprogram the end receiv-
er. If the destination has been
changed, a message is transmitted
to the new destination.
Using Key Operator Settings

Programming an End Receiver

A A A A
Press the { { { { User Tools/Counter} } } } key.
User Tools/
Counter
On Hook Dial On Hook Dial
ABC
B B B B
Select [Fax Features] using { { { { U U U U } } } } or
{ { { { T T T T } } } } , and then press the { { { { OK} } } } key.
C C C C
Select [Key Operator Tools] using
{ { { { U U U U } } } } or { { { { T T T T } } } } , and then press the
{ { { { OK} } } } key.
D D D D
Select [Forwarding] using { { { { U U U U } } } } or
{ { { { T T T T } } } } , and then press the { { { { OK} } } } key.
E E E E
Select [On] using { { { { U U U U } } } } or { { { { T T T T } } } } , and
then press the { { { { OK} } } } key.
Clear
Modes
Clear/Stop
DEF
AAN115F
77
7