Using The Flash; Recording Movies - Nikon VQA091AA Reference Manual

B
Notes About Saving Images or Movies
The indicator showing the number of exposures remaining or the indicator showing the
remaining recording time flashes, or Please wait for the camera to finish recording. is
displayed while images or movies are being saved. Do not open the battery-chamber/
memory card slot cover or remove the battery or memory card while an indicator is
flashing. Doing this could result in loss of data, or in damage to the camera or the memory
card.
C
The Auto Off Function
When no operations are performed for about one minute, the screen turns off, the camera
enters standby mode, and then the power-on lamp flashes. The camera turns off after
remaining in standby mode for about three minutes.
To turn the screen back on while the camera is in standby mode, perform an operation
such as pressing the power switch or shutter-release button.
C
When Using a Tripod
We recommend using a tripod to stabilize the camera in the following situations:
- When the flash is lowered in dark locations or when using a shooting mode in which the
flash does not fire
- When the zoom is at a telephoto position
When using a tripod to stabilize the camera during shooting, set Photo VR to Off in the
setup menu (A97) to prevent potential errors caused by this function.

Using the Flash

In situations where a flash is needed, such as in dark
locations or when the subject is backlit, raise the flash
with your hand.
When the shooting screen is displayed, you can
press the multi selector H (m) to set the flash mode.
To set the flash to always fire, select m (fill flash).
When not using the flash, gently push to lower the
flash.

Recording Movies

Display the shooting screen and press the b (e
movie-record) button to start recording a movie. Press
the b (e) button again to end recording.
Basic Shooting and Playback Operations
Shooting Images
19