[Position] Menu; [Realtime Keystone]; [Screen Adjustment] - Panasonic PT-VX615N Operating Instructions Manual

[POSITION] menu

On the menu screen, select [POSITION] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (
Note
f When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the <DIGITAL LINK/
LAN> terminal, adjust the shift and aspect from the menu of DIGITAL LINK output supported device frst.

[REALTIME KEYSTONE]

The projector can correct the vertical trapezoidal distortion automatically when the projector is installed tilted.
1) Press as to select [REALTIME KEYSTONE].
2) Press qw or the <ENTER> button.
f The [REALTIME KEYSTONE] individual adjustment screen is displayed.
3) Press qw to switch the item.
[ON]
[OFF]
Note
f Depending on the installation situation, the trapezoidal distortion may not be able to fully corrected. In this case, perform the adjustment in
the [POSITION] menu → [SCREEN ADJUSTMENT].
f [REALTIME KEYSTONE] cannot be set when the [PROJECTOR SETUP] menu → [PROJECTION METHOD] is set to [FRONT/CEILING] or
[REAR/CEILING].

[SCREEN ADJUSTMENT]

Correct the distortion when the projector is installed as tilted or the screen is tilted or curved.
1) Press as to select [SCREEN ADJUSTMENT].
2) Press the <ENTER> button.
f The [SCREEN ADJUSTMENT] screen is displayed.
3) Press as to select one item to adjust.
[KEYSTONE]
[CORNER CORRECTION]
[CURVED CORRECTION]
4) Press the <ENTER> button.
f The [KEYSTONE] screen, [CORNER CORRECTION] screen or the [CURVED CORRECTION] screen is
displayed.
Note
f Only one item of [KEYSTONE], [CORNER CORRECTION] and [CURVED CORRECTION] can be enabled. If you perform the setting of
[KEYSTONE], [CORNER CORRECTION] or [CURVED CORRECTION] and then perform the setting of the other items, the value of the
previous items will be reset.
f The image quality will deteriorate as the correction amount of [SCREEN ADJUSTMENT] increases, making focusing difficult. Install the
projector so that the correction amount is as small as possible.
f When adjustments are performed with [SCREEN ADJUSTMENT], the image size also changes.
Setting [KEYSTONE]
1) Press as to select [SCREEN ADJUSTMENT].
2) Press the <ENTER> button.
f The [SCREEN ADJUSTMENT] screen is displayed.
3) Press as to select [KEYSTONE].
70 - ENGLISH
Chapter 4 Settings - [POSITION] menu
Æ
page 61) for the operation of the menu screen.
Enables the automatic realtime keystone correction.
Disables the automatic realtime keystone correction.
Adjusts when the projected image is distorted as trapezoid.
Adjusts when the four corners of the projected image are distorted.
Adjusts when the projected image is curved distortion.