[Projector] - Panasonic PT-VX615N Operating Instructions Manual

f The items will switch each time you press the button.
[SHUT DOWN]
[OFF]
[READY]
5) Press as to select [TIMER].
6) Press qw to switch the time to be set.
f The set time is switched each time you press the button.
f You can set the time until the luminous lamp turns off with the power management function from 5 minutes
to 120 minutes in increments of 5 minutes.
Note
f The power management function can operate with Memory Viewer, MIRRORING or Panasonic APPLICATION input. Conditions to
determine that there is no input signal are as follows:
g For Memory Viewer input: no USB memory is attached to the <USB A (VIEWER)> terminal
g For MIRRORING or Panasonic APPLICATION input: no connection with devices such as a computer
Setting [STANDBY MODE]
Set the power consumption during standby.
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select [STANDBY MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[ECO]
Note
f When [STANDBY MODE] is set to [NORMAL], the network function can be used during standby.
f When [STANDBY MODE] is set to [ECO], the network function and audio output function cannot be used during standby. Also, some
RS-232C commands cannot be used.
f When set to [ECO], it may take approx. 10 seconds longer before the projector starts projecting after the power is turned on, compared with
when set to [NORMAL].
f When set to [NORMAL], it may take approx. 1 minute to enable the network function after connecting the power cord.
f The setting of [STANDBY MODE] cannot be returned to the factory default even if the [PROJECTOR SETUP] menu → [INITIALIZE ALL]
Æ
( page 94) is executed.
[RS-232C]
Set the communication address of the RS-232C control command.
For details about the connection method for RS-232C communication, refer to "<SERIAL IN> terminal" (
1) Press as to select [RS-232C].
2) Press qw to switch the item.
f The items will switch each time you press the button.

[PROJECTOR]

[DIGITAL LINK]
Note
f When [RS-232C] is set to [DIGITAL LINK], communication via the serial terminal is available only when the corresponding device (such as
the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G)) is connected to the <DIGITAL LINK/ LAN>
terminal.
90 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
The countdown timer is displayed after 30 seconds without input signal. The luminous lamp turns off
and cools down when the time set in [TIMER] has elapsed, then the projector enters into standby
status.
Power management function is off.
The countdown timer is displayed after 30 seconds without input signal. The luminous lamp will turn
off and enter into standby status after cooling down when the time set in [TIMER] has elapsed. The
luminous lamp will be turned on and enter into projection state if any signal is input or any button is
pressed during standby mode.
Select this item to use the network function during standby.
Select this item to reduce power consumption during standby.
Use the <SERIAL IN> terminal of the projector to execute RS-232C communication.
Executes RS-232C communication via the optional DIGITAL LINK output compatible device (Model
No.: ET-YFB100G, ET-YFB200G) and the <DIGITAL LINK/LAN> terminal.
Æ
page 166).