Table of Contents
Advertisement
Operations
Select the destination first, then the source, following
the procedure below.
Before starting operation, turn the power to the unit
and the system on. Then check that the PROT button
is not lit.
Selecting a source
Change the destination?
Yes
Press the desired
destination select button.
Press the desired
source select button.
End
Changing the display for a selected
destination
Is the DEST button lit?
No
The source name
connected to the selected
destination appears.
End
18
No
Yes
The selectd destination
name appears.
Setting the name for a source select
button
Use the type name?
Yes
Turn the SELECTOR knob
while holding down the
ASSIGN button.
Release the ASSIGN button.
Turn the SELECTOR knob
until the desired source name
appears.
Press the source select button
to register the selected source
name while hoding down the
ASSIGN button
End
Selecting when the unit is connected to
the monitor S-BUS data link
When you wish to monitor the input and output signals
of the DVS-V3232M/V6464M Video Routing
Switcher with an optional BKDS-V3292B Monitor
Board installed or of the DVS-128, you may switch the
monitor signals using the BKS-R1617. Before
switching signals with this unit, you should make the
signal settings at the control terminal.
For details on making the settings, refer to the Installation
Manual supplied with the routing switcher.
Lighting status of the source/destination
select buttons
The source select buttons are normally lit in dim green,
and the destination select buttons are lit in dim amber.
When you press a button for selecting a signal to be
monitored, the pressed source or destination button
lights in bright green.
No
Advertisement
Table of Contents
