Table of Contents
Advertisement
Preparations
Settings on the Control Terminal
Before switching signals with this unit, the following
preparations should be made on the control terminal
connected to the primary station of the S-BUS data
link.
For details on making the settings, refer to the installation
manual supplied with the routing switcher.
1
Set the type of the input and output connector
name to either the type name and number mode or
the description name mode.
2
Set the type names of sources, such as VTR, FLM,
AUX, etc.
Up to 32 type names may be set.
3
Set the source names using a type name and
number from 001 to 999, such as FLM034.
A list of the registered source names is called the
source table.
4
Set the destination names using a type name and
number from 001 to 999, such as VTR089.
A list of the registered destination names is called
the destination table.
5
Set the phantom names.
A list of the registered phantom names is called the
phantom table.
6
Assign the source and destination select buttons.
7
Set the level to be controlled.
8
Set the mother unit and daughter units if multiple
control units are to be used in combination as
follows:
For the mother unit
PANEL mode: MOTHER
SET BLOCK NUMBER: Block number used (1
through 10)
For daughter units
PANEL mode: DAUGHTER
MOTHER STATION ID: Station ID of the mother
unit
Note
Set the mother unit first.
9
Make the route setting if the route function is to be
used.
14
10
Set the available destination/source to limit the
input/output selection.
Preparations
You may use up to 253 control units, including this
unit, in combination to expand the number of sources
and destinations, or use this unit alone. The required
settings may differ depending on whether it is used
alone or in combination. Make the necessary settings
shown below to suit your system.
When multiple units are used in combination, define
one as the mother unit and the others as daughter units.
Setting the station number
Set the station number using the source/destination
select button 1 to 8. The station number is obtained by
adding the binary place values of the buttons that are
lit. For example, if the buttons 1, 2 and 4 are lit as
shown below, the station number is 11 (=1+2+8).
1
2
3
Not Lit
0
0
0
Lit
1
2
4
1
2
3
Examples of
setting a station
1 +
2
+
0
number 11
Note
Do not assign the same number to more than one unit
in a routing system.
1
Press and hold the LOCK (CHOP) and PROT
buttons for about five seconds to reset the
software.
2
Press and hold the source/destination select buttons
1, 2, 3, and 4 during being rebooted to enter station
number setting mode.
Note
When the power is turned ON for the first time,
station number setting mode is automatically set,
and steps 1 and 2 are not required.
4
5
6
7
8
0
0
0
0
0
8
16
32
64 128
4
5
6
7
8
+
8
+
0
+
0
+
0
+
0
=
11
Advertisement
Table of Contents
