Settings By Using The Buttons (Setup Function) - Sony BKS-R1617 Operation Manual

Multi display control unit
Hide thumbs Also See for BKS-R1617:
Table of Contents

Advertisement

Preparations
Attaching a key label
Attach the key labels to the buttons with the following
procedure.
1
Attach the key-cap puller to the indentations of the
sides of the key cap.
You can easily attach the puller if you press the
buttons on both sides.
2
Remove the key cap by pulling the key-cap puller.
3
Rotate the key-cap puller downwards while
pinching the key-cap, and pull it down to separate
the key cap, and diffuser.
4
Put the key cap, key label with the name written,
and diffuser on the button and replace them as they
were.
As for the key-cap puller (part number: 3-179-054-01),
consult your Sony personnel.
1, 2
Key-cap puller
3
Key-cap puller
16
Attach the key-cap
puller here.
4
Key cap
Key label
Diffuser
Settings by Using the Buttons
(Setup Function)
With the S-BUS system, the necessary items are
normally set at the control terminal connected to the
primary station. However, the following items may be
set on the unit by turning the power on while holding
down the two or more select buttons, as described
below.
Number of the source/destination select buttons
BKS-R1617
1
2
3
4
5
6
7
8
BKS-R1621
1
2
3
4
5
6
9
10 11 12
13 14 15 16
Initializing the settings
While holding down buttons 1 and 2, turn the power
on.
The following items are set to the factory-set
conditions.
1) Status display mode
2) Single-use mode
3) Phantom partial-protect mode
Note
Press buttons until the lamp check on the panel is
completed
Setting single-use mode
While holding down buttons 5 and 8, turn the power
on.
Use this mode when this unit is to be used alone.
Setting prompt lamp-light mode
While holding down buttons 1 and 3, turn the power
on.
When you press a source select button, the lamp of the
pressed button promptly lights.
Setting status display mode
While holding down buttons 1, 2 and 3, turn the power
on.
When you press a source select button, the system
checks that the designated crosspoint has been
switched, then the button lights according to the
crosspoint status.
9 10 11 12
13 14 15 16
7
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bks-r1621

Table of Contents