Welbilt Frymaster FilterQuick 3FQG30U Installation, Operation And Maintenance Manual page 53

FILTERQUICK™ FQG30 SERIES GAS FRYER
APPENDIX C: Solid Shortening Melting Unit Use
 Ensure shortening melting unit is on.
 Fill melting unit with shortening.
 Allow 2-3 hours for solid shortening to
melt. DO NOT attempt to use the top off
system with unmelted oil in the top off
system. The low oil message will be
displayed if the fryer calls for oil before
the shortening in the melting unit is
liquid.
 Once the shortening is fully melted,
press and hold the orange reset button
to reset the top off system.
 DO NOT ADD hot oil to the shortening
melter. The temperature of the oil
reservoir should not exceed 140°F
(60°C). Add small amounts of solid
shortening to the reservoir to ensure it
has sufficient oil to operate the top-off
system.
 For best results, DO NOT TURN OFF
the solid shortening melting unit
overnight.
 The power switch for the melting unit is
also used as a reset switch if the
system's high limit temperature is
reached.
Reset oil reservoir system
C–1
WARNING
The surfaces of the solid shortening
heater are hot. Do not touch with
bare hands. Wear protective clothing
when adding shortening to melting
unit.
Melting
unit
power
switch
Lift carefully
to add
shortening.