Using The Core From A Used Paper Roll As A Take-Up Reel Core; Specifications - Epson Stylus Pro 10000 User Manual

Using the core from a used paper roll
as a take-up reel core
Before you install a used paper roll as the take-up
reel core, note and check the following:
❏ If the paper roll core is deformed or damaged,
it cannot be used as a take-up reel core.
❏ Make sure that there is no looseness between
the core and the flanges on the drive unit and
movable unit.
❏ To wind up 36-inch wide roll paper, use a 44-
inch wide take-up reel core. To wind up 44-
inch wide roll paper, use a 46-inch paper roll
core. (The optional Take-Up Reel Core
[C815091] for 44-inch wide roll paper is
available for purchase. Contact your dealer.)
Diameters of the knobs on the flange are shown
below.
76.2mm (3")
Length of the take-up reel core as related to the
width of the roll paper is shown below. Keep a gap
of at least 20 mm between the flanges and the right
and left edges of the roll paper, otherwise the roll
paper cannot be wound up with the auto take-up
reel unit properly.
20mm gap (at least)
Downloaded from: http://www.usersmanualguide.com/
50.8mm (2")
Roll paper
20mm gap (at least)
The installation of the Auto Take-up Reel Unit is
complete. When you use the unit, see the Reference
Guide.

Specifications

Note:
❏ This product is designed for use with printer
models P260 (A, B or C)
❏ This product conforms to CE marking
requirements in accordance with EC Directive
898/336/EEC.
Usable paper width Max. 1118 mm, min. 210 mm
Paper length No greater than a 10 cm roll
diameter on a 2-inch core,
or a 15 cm roll diameter on a
3-inch core.
Max. sheet diameter 180 mm (paper must not
after take-up come in contact with the top
horizontal strut between the
uprights of the base unit)
Flange rotation speed 63 rpm
Power supply AC 5 V/28 V
Rated current 2 A/2 A
Operating noise 50 dB
Unit weight 4.25 kg
Operating environment Temperature: 10 to 35°C
(without condensation) Humidity: 20 to 80% (without
condensation)
7